Ceiling materials have a lot of common gypsum board ceiling, solid wood ceiling are currently more popular, different materials decoration effect is not the same, the applicable space is not the same, aluminum ceiling is generally used in the centralized office building, or home bathroom, etc., aluminum ceiling modeling is not as exquisite as other materials, but the practicality of the higher, the price is also more affordable. Aluminum ceiling method and other ceiling there is not much difference, just in some of the subtle process there are some differences.
Today we will share with you Mingtan aluminum veneer manufacturer: aluminum ceiling construction preparation:
Preparation of basic materials:
Aluminum alloy square plate sheet, keel, boom and other materials, impact drills, toothless saws, hacksaws, nail guns, screwdrivers, cable hammer, angle ruler and other construction tools grass-roots pop-up line
After preparing the basic materials, first of all, we have to decorate the floor according to the elevation of the horizontal line, according to the designed elevation, find out the center point of the decorated room, and along the entire ceiling elevation level, to the center of the room as the center of the center of the keel in the wall to draw a good staging position line.
Install the main keel ceiling:
After drawing the ceiling elevation line and the staging position line of the keel, we start to determine the elevation of the lower end of the boom, and then install the ceiling that has been processed, the ceiling installation needs to be fixed on the ceiling with pa expansion bolts.
The main keel is generally selected C38 light steel keel, spacing control in the range of 1200mm, the installation of the ceiling with the main keel supporting the connection with the boom. According to the net height of the ceiling requirements in the wall around the cement nails fixed 25 * 25mm baking paint keel, cement nails spacing is not greater than the installation of secondary keel.
The secondary keel is hung on the main keel through the hanging piece, when the length of the secondary keel needs to be more than one continuation of the extension, use the secondary keel connector, while hanging the secondary keel, the relative ends will be connected, and first straighten and then fixed.
Installation of metal plate:
After the main keel, side keel, secondary keel is installed, we need to set up a good baseline along the direction of the vertical secondary keel in the middle of the assembly area, and then align the baseline to install to both sides respectively. During the installation, pay attention to hold lightly, at the same time must follow the flap part in accordance with the order of the two sides of the square plate gently pressed, stuck into the keel and then pushed tight.
Cleanup:
Aluminum buckled plate after installation, need to use a cloth to wipe the board surface all clean, there shall be no dirt and handprints and so on.
Aluminum ceiling effect is very atmospheric, suitable for relatively large space use, and is not easy to moisture, the use of life is also very long, aluminum ceiling need to be professionally prepared in advance tools, aluminum construction tools are relatively simple, are more common, but the size of the material should be planned in advance, so as not to appear in the installation of the size of the situation is not appropriate. Aluminum ceiling is mainly fixed by the keel frame, aluminum ceiling construction quality must be guaranteed, each process should be fine in place to avoid falling off.
Online customer service